Finally, a brilliant new solution for edge jointing solid wood panels. Once you’ve seen the Frontline system, you’ll never use sash cramps again. It’s so easy!
1. Lift off the upper clamp bar 2. Lay up the glued pieces 3. Replace the upper clamp bar 4. Wind the handle...
No more trial and error tightening while you try to obtain a flat panel with your mallet!
Better joints too, because adjusting flatness by mallet tends to wipe glue off the faces.
At least four times faster than sash cramps, plus a whole lot less planing and sanding!	Fully anodised structural aluminum. Fully adjustable from 10mm to 75mm . Comes in two standard sizes. Clamps opening capacity 920mm & 1220mm. Also 1520mm capacity available on request.
< Previous Index 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | Next >